Cisco IP Phone 79xx series. SIPDefault.cnf

Cisco IP Phone 79xx series. SIPDefault.cnf

В файле SIPDefault.cnf задаются параметры по умолчанию для всех телефонов

Формат задания параметров в конфигурационном файле: имя_переменной : значение ; необязательный комментарий

Пример конфигурационного файла:

# SIP Default Configuration File

# Image Version

image_version: P0S3-8-12-00

# Proxy Server

proxy1_address: 172.16.255.255

proxy2_address:""; Can be dotted IP or FQDN

proxy3_address:""; Can be dotted IP or FQDN

proxy4_address:""; Can be dotted IP or FQDN

proxy5_address:""; Can be dotted IP or FQDN

proxy6_address:""; Can be dotted IP or FQDN

# Proxy Server Port (default - 5060)

proxy1_port: 5060

proxy2_port: 5060

proxy3_port: 5060

proxy4_port: 5060

proxy5_port: 5060

proxy6_port: 5060

# Proxy Registration (0-disable (default), 1-enable)

proxy_register: 0

# Phone Registration Expiration [1-3932100 sec] (Default - 3600)

timer_register_expires: 3600

# Codec for media stream (g711ulaw (default), g711alaw, g729a)

preferred_codec: g711ulaw

# TOS bits in media stream [0-5] (Default - 5)

tos_media: 5

# Inband DTMF Settings (0-disable, 1-enable (default))

dtmf_inband: 1

# Out of band DTMF Settings

#(none-disable, avt-avt enable (default), avt_always-always avt)

dtmf_outofband: avt

# DTMF dB Level Settings

#(1-6dB down, 2-3db down, 3-nominal (default), 4-3db up, 5-6dB up)

dtmf_db_level: 3

# SIP Timers

timer_t1: 500; Default 500 msec

timer_t2: 4000; Default 4 sec

sip_retx: 10; Default 10

sip_invite_retx: 6; Default 6

timer_invite_expires: 180 ; Default 180 sec

####### New Parameters added in Release 2.0 #######

# Dialplan template (.xml format file relative to the TFTP root directory)

dial_template: dialplan

# TFTP Phone Specific Configuration File Directory

tftp_cfg_dir: ""; Example: ./sip_phone/

# Time Server

#(There are multiple values and configurations refer to Admin Guide for Specifics)

sntp_server: ""; SNTP Server IP Address

sntp_mode: anycast (default); unicast, multicast, or directedbroadcast

time_zone: EST; Time Zone Phone is in

dst_offset: 1; Offset from Phone's time when DST is in effect

dst_start_month: April; Month in which DST starts

dst_start_day: ""; Day of month in which DST starts

dst_start_day_of_week: Sun; Day of week in which DST starts

dst_start_week_of_month: 1; Week of month in which DST starts

dst_start_time: 02; Time of day in which DST starts

dst_stop_month: Oct; Month in which DST stops

dst_stop_day: ""; Day of month in which DST stops

dst_stop_day_of_week: Sunday; Day of week in which DST stops

dst_stop_week_of_month: 8; Week of month in which DST stops 8=last week of month

dst_stop_time: 2; Time of day in which DST stops

dst_auto_adjust: 1; Enable(1-Default)/Disable(0) DST automatic adjustment

time_format_24hr: 1; Enable(1 - 24Hr Default)/Disable(0 - 12Hr)

# Do Not Disturb Control

#(0-off (default), 1-on, 2-off with no user control, 3-on with no user control)

dnd_control: 0;

# Caller ID Blocking

#(0-disabled, 1-enabled, 2-disabled no user control, 3-enabled no user control)

callerid_blocking: 0; (Default is 0 - disabled and sending all calls as anonymous)

# Anonymous Call Blocking

#(0-disabled, 1-enabled, 2-disabled no user control, 3-enabled no user control)

anonymous_call_block: 0; (Default is 0 - disabled and blocking of anonymous calls)

# DTMF AVT Payload (Dynamic payload range for AVT tones - 96-127)

dtmf_avt_payload: 101; Default 101

# Sync value of the phone used for remote reset

sync: 1; Default 1

####### New Parameters added in Release 2.1 #######

# Backup Proxy Support

proxy_backup: ""; Dotted IP of Backup Proxy

proxy_backup_port: 5060; Backup Proxy port (default is 5060)

# Emergency Proxy Support

proxy_emergency: ""; Dotted IP of Emergency Proxy

proxy_emergency_port: 5060; Emergency Proxy port (default is 5060)

# Configurable VAD option

enable_vad: 0; VAD setting 0-disable (Default), 1-enable

####### New Parameters added in Release 2.2 ######

# NAT/Firewall Traversal

nat_enable: 0; 0-Disabled (default), 1-Enabled

nat_address: ""; WAN IP address of NAT box (dotted IP or DNS A record only)

voip_control_port: 5060; UDP port used for SIP messages (default - 5060)

start_media_port: 16384; Start RTP range for media (default - 16384)

end_media_port: 32766; End RTP range for media (default - 32766)

nat_received_processing: 0; 0-Disabled (default), 1-Enabled

# Outbound Proxy Support

outbound_proxy: ""; restricted to dotted IP or DNS A record only

outbound_proxy_port: 5060; default is 5060

####### New Parameter added in Release 3.0 #######

# Allow for the bridge on a 3way call to join remaining parties upon hangup

cnf_join_enable: 1; 0-Disabled, 1-Enabled (default)

####### New Parameters added in Release 3.1 #######

# Allow Transfer to be completed while target phone is still ringing

semi_attended_transfer: 1; 0-Disabled, 1-Enabled (default)

# Telnet Level (enable or disable the ability to Telnet into the phone)

telnet_level: 1; 0-Disabled (default), 1-Enabled, 2-Privileged

####### New Parameters added in Release 4.0 #######

# XML URLs

services_url: ""; URL for external Phone Services

directory_url: ""; URL for external Directory location

logo_url: ""; URL for branding logo to be used on phone display

# HTTP Proxy Support

http_proxy_addr: ""; Address of HTTP Proxy server

http_proxy_port: 80; Port of HTTP Proxy Server (80-default)

# Dynamic DNS/TFTP Support

dyn_dns_addr_1: ""; restricted to dotted IP

dyn_dns_addr_2: ""; restricted to dotted IP

dyn_tftp_addr: ""; restricted to dotted IP

# Remote Party ID

remote_party_id: 0; 0-Disabled (default), 1-Enabled